Could do with a little bit of advice off any plumbers out there, or anyone with some know how. l have just bought and fixed a 'p' trap with washer and dishwasher connectors.The fixings fine and the two 135 degree bends on the inlet stalk are to both appliances.The dishwasher hose has a rubber collet on the end of the hose and this is pushed onto the bend and tightened with a clamp, no problem, no leaks.The washing machine has no rubber on the end of the hose, but is pushed onto the bend and again clamped with a jubilee clip but it leaks water when the washer is on.The clips are on really tight, so any ideas- and why wou;ld it still leak.
slow leak
- Thread starter ray316
- Start date
Sponsored Links
Wrong sort of wm hose to go on to a spigot then - or the rubber collar on the end has been cut off? If you just have a ribbed end you'll have to fill it with silicone and use your hose clamp. Ordinary silicone would do, or Fernox LS-X.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
