Hi. Ive just bought a new Smeg dishwasher DI6012 and all was going well with the installation until I realised that the appliance was about 3 inches too low! So, I found the feet (there are 3) and the nut at the front that adjusts the rear foot. The problem is the feet at the front - they are little round black grooved disks about 1 inch in diameter, and I just cannot move them at all.
Am I missing something? Maybe a little screw somewhere that adjusts them? The deeply unhelpful instruction manual just says "adjust the feet until they are the right height". It does not say how!
Am I missing something? Maybe a little screw somewhere that adjusts them? The deeply unhelpful instruction manual just says "adjust the feet until they are the right height". It does not say how!
