Hi I'm new to this forum so I hope I'm not raising an old question.
Is there an accepted technique for soldering T&E solid core ring-main cable ends? I know I could replace the cable run but that would not be straightforward. I currently have one of the circular 30A connector units joining the two ends under the floor. I've soldered for years on lightweight wires and circuit boards, I just need to know if there is an accepted technique for preparing the cable ends prior to soldering and then covering them wth heat shrink?
Is there an accepted technique for soldering T&E solid core ring-main cable ends? I know I could replace the cable run but that would not be straightforward. I currently have one of the circular 30A connector units joining the two ends under the floor. I've soldered for years on lightweight wires and circuit boards, I just need to know if there is an accepted technique for preparing the cable ends prior to soldering and then covering them wth heat shrink?