As my kitchen saga continues, ive realised that i havent quite measured up correctly, as i was expecting all worktops to be 6oomm deep, However it turns out that one set of wall units has been stood off the wall to make them run level
I measured the worktop and it needs to be 630mm deep, will i be able to cut some strips of an off cut and screw/ fasten them to the back of the 600mm wide worktop? Its a solid wood, butchers block style worktop I plan to tile and use a small trim to cover any inperfections and i am getting a joiner in to do it hopefully tomorrow or friday, but im worried about it now, what do you think?
Andy
I measured the worktop and it needs to be 630mm deep, will i be able to cut some strips of an off cut and screw/ fasten them to the back of the 600mm wide worktop? Its a solid wood, butchers block style worktop I plan to tile and use a small trim to cover any inperfections and i am getting a joiner in to do it hopefully tomorrow or friday, but im worried about it now, what do you think?
Andy