- Joined
- 31 Aug 2013
- Messages
- 261
- Reaction score
- 1
- Country
Basically it was my 2nd time using self levelling compound and the floor came out 90% flat, however there is a high spot in one area (almost a ridge) and a low section in another. Luckily they are near the threshold areas, so I'm going to peel back and address the issue rather than leave the spring in the floor.
Questions is how do I reduce the high spots without expensive equipment?, how do I sort the low spot? I was going to buy some no nonsense self leveling because its about 1m2 and out by 20 mm in the corner. Packing under this area with additional underlay doesn't seem to be working out very well
Suggestions welcome
Questions is how do I reduce the high spots without expensive equipment?, how do I sort the low spot? I was going to buy some no nonsense self leveling because its about 1m2 and out by 20 mm in the corner. Packing under this area with additional underlay doesn't seem to be working out very well
Suggestions welcome
