Hi... I have a 13amp socket in my garage that's run from a consumer unit (in the garage) as one socket is not eough I was wondering if i coud run a spur from that socket even though there is only one cable coming into it. would appreciate any assistance.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
spur from a consumer unit in garage
- Thread starter como08
- Start date
thanks for quick reply. on the cu in garage it states "not to exceed 45 amps" and the fuse inside is 15amp. hope this makes sence!
You may add as many sockets as you like - use 2.5mm² cable.
Thanks for the replies lads. it pus my mind at ease.
I will bet there is not an RCD in that garage fuseboard?
If not then is there on protecting the circuit to the garage?
It is important that the old, and the new, sockets have RCD protection.
If not then is there on protecting the circuit to the garage?
It is important that the old, and the new, sockets have RCD protection.
Indeed, although as the wiring will almost certainly be clipped direct on the surface of the brick, you can get the required protection by installing RCD socket fronts. Not the most cost effective solution perhaps, but requires no messing with the consumer unit.
with regard to the query about RCD . There is an RCD switch on the main consumer unit ,which covers the garage, in the house. The house is 6 years old.
Well in that case, you're good to go 
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
