Staircase glue/adhesive?
- Thread starter gemshan1
- Start date
Sponsored Links
D4 Wood Glue
• Dries clear• Waterproof• Solvent free• Interior and exterior useSolvent free industrial grade, high strength wood adhesive. Totally waterproof, impact and temperature resistant, and sets in just 10 minutes. Meets the requirements of EN204 and WATT 91.This D4 grade wood glue is an ideal option...
keep the glue warm [around 20 degrees ] and wood at least 15 degrees to aid drying time do not use below around 10 degrees
now in general wedged wood will self hold and give full strength to the joint instantly but nailed or clamped will need about an extra hour to dry per 3-5 degree drop in temperature below 20 to a point about perhaps 5 degrees it can take all day to grip and 24 hours to cure
but never let the glue drop below perhaps 5 degrees in storage-------aaaaand most important remove the witches hat from the top off the glue bottle cut off the visible pin about 3mm down on the larger section below the X holding the pin to make a mushroom shape return the witches hat to the now large hole and the mushroom is now a stopper for the bottle
and do not use the bottle without the witches hat unless you need a massive wide area covered
a 1-2mm bead twice across a 15-20mm surface will be more than enough and give a perhaps 80-100% cover or a single 3-5mm will give a 80 to 120% cover with loads off ooze
d4 works best on very tight and clamped where its forced into the surface and becomes a microfilm and dries quickly
now in general wedged wood will self hold and give full strength to the joint instantly but nailed or clamped will need about an extra hour to dry per 3-5 degree drop in temperature below 20 to a point about perhaps 5 degrees it can take all day to grip and 24 hours to cure
but never let the glue drop below perhaps 5 degrees in storage-------aaaaand most important remove the witches hat from the top off the glue bottle cut off the visible pin about 3mm down on the larger section below the X holding the pin to make a mushroom shape return the witches hat to the now large hole and the mushroom is now a stopper for the bottle
and do not use the bottle without the witches hat unless you need a massive wide area covered
a 1-2mm bead twice across a 15-20mm surface will be more than enough and give a perhaps 80-100% cover or a single 3-5mm will give a 80 to 120% cover with loads off ooze
d4 works best on very tight and clamped where its forced into the surface and becomes a microfilm and dries quickly
Last edited:
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
