Hi all,
I have been looking into why my rads and hot water are warm rather than hot and noticed that the boiler was only lit for a few seconds at most. However, when I opened the cover the boiler stayed lit until it reached temp. Presumably then this is something to do with air flow?
The fan spins freely and appears to work ok and there is nothing blocking the flue. There are two small pipes / tubes that enter from the control side of the boiler - a clear one that connects to the bottom of the fan housing which appears to have closed up where it bends to connect at the fan, and a red pipe with a small metal insert that does not connect to anything. Is my problem related to either of these tubes?
Any help greatly appreciated
Thanks
I have been looking into why my rads and hot water are warm rather than hot and noticed that the boiler was only lit for a few seconds at most. However, when I opened the cover the boiler stayed lit until it reached temp. Presumably then this is something to do with air flow?
The fan spins freely and appears to work ok and there is nothing blocking the flue. There are two small pipes / tubes that enter from the control side of the boiler - a clear one that connects to the bottom of the fan housing which appears to have closed up where it bends to connect at the fan, and a red pipe with a small metal insert that does not connect to anything. Is my problem related to either of these tubes?
Any help greatly appreciated
Thanks