Tap Connection - help!

[Jonnyk123]

Hi all

I am fitting a new tap and want to avoid the use of copper as I have no experience of plumbing/soldering.

I have chosen to use a flexible tap connector. However, I only have a small space between the water feed and the tap tail. A 300mm will not be possible. I wouldn't even be able to loop it.

I do know that 150mm connectors exist, although I need one to fit onto an isolation valve and the tap the other end. Seems like finding a needle in a haystack!

Does anyone know of anywhere that can supply this?
I have attached an image of what im dealing with. The tap tail is longer than shown on the image.

View media item 72715
Any help will be appreciated.

Jonny

 

[Jackrae]

You could use a longer flexible (say 600mm) and loop it. Chances of bending a 150mm through such a tight right-angle without kinking it are slim.