The error codes on my hoover hed 6612-80 diswasher show there is a fault with the temperature sensor. Could any tell me if you can test this in any way, also where can I obtain a new sensor as I've been on the internet and cannot find one. Thank you for your help in this matter..
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
testing temperature sensor, getting hold of a new one.
- Thread starter davidcu
- Start date
http://www.espares.co.uk/parts?k=49009410
What flashing LED sequence are you actually seeing?....you may be barking up the wrong tree.
What flashing LED sequence are you actually seeing?....you may be barking up the wrong tree.
The pre-wash, wash light and rinse light brighten up simultaneously. Have checked temperature of the water and it is stone cold.
That only tells you that it isn't heating, it doesn't specifically mean that the NTC has failed. NTC's don't fail that often & a no-heat issue could be caused by any of the following: Defective heater element, bad NTC, broken wiring/bad connection in the heating circuit, or a duff pcb. Check the first two with your multimeter & take a peek at the wiring. If all is ok then the heater relay on the pcb has failed.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local