I've attached a smoke alarm to my texecom premier 24 but wanted to configure a latched output onto the panel as digi output 1.
I've configured the smoke alarm as a fire zone and normally closed. II'm able to successfully trigger the fire alarm but unable to reset the smoke alarm using the latched output though I've set the output to latched (also confirmed this using a meter).
I'm obviously missing something but not sure what, any advice?
I've configured the smoke alarm as a fire zone and normally closed. II'm able to successfully trigger the fire alarm but unable to reset the smoke alarm using the latched output though I've set the output to latched (also confirmed this using a meter).
I'm obviously missing something but not sure what, any advice?