so panel was sending to 192.168.1.125 on 10001, worked in SIA or contact ID, not shown texbase, but that would be the next steo.
hope this helps, I have run on a version 9.02 but cant be sure I have ever run a version 8 panel, but didn't see anything in the old panel info in wintex as to it being updated so should work.
without looking into it any further, not much I can say, don't need leading zeros for it to work.
check its setup correctly, stop the coms and ip and restart them, should see the 5 as in receive data snap shot.
I setup a panel and montex and texbase from scratch, took longer to boot the laptop so I could access the panel, than it did to setup and test.
hope this helps, I have run on a version 9.02 but cant be sure I have ever run a version 8 panel, but didn't see anything in the old panel info in wintex as to it being updated so should work.
without looking into it any further, not much I can say, don't need leading zeros for it to work.
check its setup correctly, stop the coms and ip and restart them, should see the 5 as in receive data snap shot.
I setup a panel and montex and texbase from scratch, took longer to boot the laptop so I could access the panel, than it did to setup and test.