texecom veritas 8, either part set or omit zones

Joined
7 Aug 2011
Messages
161
Reaction score
0
Location
Lancashire
Country
United Kingdom
Afternoon, few weeks I posted on here but with my explanation could not sorted it out.

It came down to the tamper spring on the panel which is now sorted.

Could someone help in easy terms how to set up either part or omit zones , so in the evening these can be set while where asleep, I have four zones to set up , any help is much appreciated
 
Joined
20 Jun 2014
Messages
5,772
Reaction score
751
Location
Lancashire
Country
United Kingdom
advise on how you want the zones to work.

ie which ones to cause an alarm, which you want to start the entry, which you want to not work at all when part set.
 
Sponsored Links
Joined
7 Aug 2011
Messages
161
Reaction score
0
Location
Lancashire
Country
United Kingdom
Hi there before we entered either full or code to exit property, and code to enter.

Need to reset it so zones, so at nighttime the kitchen and one room is active, so two bedroom and hallway are free to roam please
 
Joined
20 Jun 2014
Messages
5,772
Reaction score
751
Location
Lancashire
Country
United Kingdom
if you look at the manual
enter engineering and set up the part set suite make sure all zones not in use during part set are selected to be omitted.

its a little more complicated for the kitchen and room one.

depends on where your keypad is located and when its part set do you activate the kitchen or room one first when you get up to disarm the system or not at all?
 
Sponsored Links
Top