Hi,
We've spent the last 6 months doing an extension and have the tilers coming in for the bathroom late September. Thought I'd best pick up where I'd left off and make sure everything was in place before they came.
Had left the thermostatic shower in it's box after a quick look over when it arrived a few months back and thought nothing of it until looking a bit closer at the connector today and it's not what I'd planned for, just leaving the 2 x 15mm sticking out the backer board 150mm apart.
Stupidly I'd expected the a male - male offset connector and i'd sub it out for one of the fast fix brackets over the tiling. But this has a male - brass sleeve held in by a grub screw.
Is there a surface mount fitting system that connects to this or am I looking at taking the backer board off and having to fit a 15 x 3/4" end feed or something in the wall?
Thanks in advance
We've spent the last 6 months doing an extension and have the tilers coming in for the bathroom late September. Thought I'd best pick up where I'd left off and make sure everything was in place before they came.
Had left the thermostatic shower in it's box after a quick look over when it arrived a few months back and thought nothing of it until looking a bit closer at the connector today and it's not what I'd planned for, just leaving the 2 x 15mm sticking out the backer board 150mm apart.
Stupidly I'd expected the a male - male offset connector and i'd sub it out for one of the fast fix brackets over the tiling. But this has a male - brass sleeve held in by a grub screw.
Is there a surface mount fitting system that connects to this or am I looking at taking the backer board off and having to fit a 15 x 3/4" end feed or something in the wall?
Thanks in advance