Tight base unit run

[mrkjd]

I have a run of base units running along a wall from corner to corner starting with a corner base and ending with a tall larder unit. I have a tall end panel to fit on the exposed side of the tall unit next to a base unit but measuring up post plastering of walls etc things are getting tight! I am wondering if I can fit the end panel from tall cabinet top to the top of the next base cabinet rather than all the way to the floor (which is what has been done in the plan) which will give me 22mm more wiggle room. Is this possible? Worktops have not been templated yet.

 

[KenGMac]

mrkjd, good evening.

Short answer is yes, fit the decor panel so that the Worktops when fitted butt against it, job done, and some space to work in.

As an aside? could you get a replacement smaller [in height] decor panel? and get a return the full height one? Just a consideration?

Ken