Hello all,
I have a pig of a bathroom to do . The layout works best if there is a small tile directly either side of the window. I’ve agonised with various permutations but this seems best. Anyway, I have cut 5 tiles trying to get the first cut tile to fit, I know you are supposed to butt the tile right up to where the trim would be but this is impossible. The trim is 8mm aluminium angle and has no lip so is non- forgiving. I fear it would be difficult to get a horizontal to butt against it let alone a vertical at a right angle too. See pic: this is the best I can do. There will be gaps out to the side of the trim. Even the thickness of the pen I’m marking the tile with makes the difference depending on if you cut through the middle, below the mark or above the mark. I’m at my wits end with it. Any advice appreciated. Would the tiles shown look awful when brought? Thank you?
I have a pig of a bathroom to do . The layout works best if there is a small tile directly either side of the window. I’ve agonised with various permutations but this seems best. Anyway, I have cut 5 tiles trying to get the first cut tile to fit, I know you are supposed to butt the tile right up to where the trim would be but this is impossible. The trim is 8mm aluminium angle and has no lip so is non- forgiving. I fear it would be difficult to get a horizontal to butt against it let alone a vertical at a right angle too. See pic: this is the best I can do. There will be gaps out to the side of the trim. Even the thickness of the pen I’m marking the tile with makes the difference depending on if you cut through the middle, below the mark or above the mark. I’m at my wits end with it. Any advice appreciated. Would the tiles shown look awful when brought? Thank you?