Need advice on how they get around a curved driveway. It's on a slope and curve's on both sides to the parking area right outside the house.
It's the bullnose concrete thin curbs getting installed as edging beside 60mm paving blocks. I want to come around the 2 curves with nice mitred cuts instead of just guessing it.
How do I go about calculating the measurements so I can get the exact cuts.
Might be a question for a carpenter or a roofer but thought best to put in here as it's a general building question.
It's the bullnose concrete thin curbs getting installed as edging beside 60mm paving blocks. I want to come around the 2 curves with nice mitred cuts instead of just guessing it.
How do I go about calculating the measurements so I can get the exact cuts.
Might be a question for a carpenter or a roofer but thought best to put in here as it's a general building question.