two gang switch
- Thread starter ereilly26
- Start date
More information is required really for people to answer your question!
In the mean time have a look in the for reference section on this forums front page http://www.diynot.com/forums/viewtopic.php?t=7553
Hope this helps.
Be careful electricity has no Friends......
In the mean time have a look in the for reference section on this forums front page http://www.diynot.com/forums/viewtopic.php?t=7553
Hope this helps.
Be careful electricity has no Friends......
From the old switch....marry the new.
L1 is L1
L2 is L2
Com is Com
There are 2 switches, so this will be mirrored to the other, but usually upside down.
Shouldn't have to much of a struggle
L1 is L1
L2 is L2
Com is Com
There are 2 switches, so this will be mirrored to the other, but usually upside down.
Shouldn't have to much of a struggle
Remember to earth the brass front plate from the metal back box, if you have no earth at the switch, then DONT fit a brass switch until this is rectified. If you have no earth, then you should have NO metal light fittings either.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
