Up and over garage door - detached cable

Joined
20 Mar 2004
Messages
174
Reaction score
5
Country
United Kingdom
Hi. The pic shows the type of garage door I have. A slam caused by high wind has left one side wonky with the cable off its grooves. I unclipped the cable from the plastic cone but can't figure out how to put it back.

Do you start with the door in the closed position? That seems logical to me but I just can't stretch the wire enough to clip it in.

My thanks for any pointers offered.
grgdr.jpg
 
Sponsored Links
You need to take tension off the spring. But be careful as you can mak the situation far worse. Google, the make fo your garage dooe & there will be lots of videos on how to replace the cables
 
As said there are loads of videos. Be aware that you can seriously hurt yourself if it goes tits up.
The guy on a video I watched used a piece of metal stock so that it was jammed against the building while working- as a safety measure

I did one myself before YouTube was around and it was quite scary.
You could easily loose a finger if you're not careful
 
Looks like I'm gonna get professional help, then. Thanks guys.
 
Sponsored Links
As said there are loads of videos. Be aware that you can seriously hurt yourself if it goes tits up.
The guy on a video I watched used a piece of metal stock so that it was jammed against the building while working- as a safety measure

I did one myself before YouTube was around and it was quite scary.

It's a fairly common issue, the cables coming of these doors....

I reattached mine a few times, before I finally replaced the door with an electric roller shutter door. The spring has the minimum tension on it with door fully open, unfortunately that is usually when you cannot access it as the door is then in the way - as in my case. I ended up with door closed, tensioning it with pulleys, then clamping the cable under tension with two Mole clamps to the steel frame, to allow the cable to be reconnected to the hook on the door. It was bloody scary doing it - I wore thick leather gloves, a heavy coat and a face mask just in case.

You could easily loose a finger if you're not careful
,

You can loose much more than a finger, if it goes wrong. Mine uses a pair of coil springs, in a channel above the door, stretched lengthwise to apply tension. For around £450 I decided to buy and fit myself, a remote control electric roller shutter - which is much more convenient and not nearly as dangerous when it goes wrong :)
 
Actually, it turned out to be simple. A neighbour with an engineering background had a look at it for me. With the door closed, he used a spanner to turn the spring rod a wee bit which enabled the cable to reach the slot on the cone. The door then opened as normal.
 
Well done. They are quite simple. I use molegrips on the cones & axles for safety when I need o adjust mine. Note: you are not supposed to use grease on the runners. A mistake a lot of people make.
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top