- Joined
- 7 Jan 2019
- Messages
- 5
- Reaction score
- 0
- Country
Is there any way to use two 2-channel Hive receivers in the same system using the Hot Water circuit on the second receiver to control an immersion heater via a 40A relay?
Using two 2 channel Hive receivers in one system to control immersion heater
- Thread starter Brian McHugh
- Start date
- Joined
- 27 May 2011
- Messages
- 2,278
- Reaction score
- 1,236
- Country
Must it be Hive?
I'm sure there are cheaper internet-enabled switches to operate your relay.
I'm sure there are cheaper internet-enabled switches to operate your relay.
- Joined
- 27 Jan 2008
- Messages
- 28,467
- Reaction score
- 3,457
- Location
- Llanfair Caereinion, Nr Welshpool
- Country
A motorised valve is a relay, so yes, the relay replaced the motorised valve, but why?
- Joined
- 5 Nov 2024
- Messages
- 4,947
- Reaction score
- 2,367
- Country
You do realise the question is about an immersion heater?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
