hello there i have a problem with the above boiler i was removed from a property which was having an upgrade and was working perfectly before removal ,after plumbing it in up my loft to a single rad and a tap to check before fully conecting in to my system it seems that once i switch it to heating it fires and ignites burns for about 30 seconds and the the burner cuts out still leaving the pump running the temp rises to about 30 degrees has any one else had this problem p.s if i call for water that operation is fine
vaillant turbowmax 242e heating problem
- Thread starter hardtail
- Start date
Sounds like the CH circuit is blocked. Have you opened the isolation valves and rad valves?
The boiler should really be properly commissioned as if it were a new installation. You may want to engage a Corgi heating engineer to do this.
The boiler should really be properly commissioned as if it were a new installation. You may want to engage a Corgi heating engineer to do this.
was comissioned to the book my corgi laspsed last year. yes mate all open
tryed all it is on max at to moment i have to switch boiler off and on before it will relight some times it stays on longer than other ,max temp it reached was 60 and the heating was turned up to max
anyone else
there is a little blue limet switch towards the bact of the boiler if i please it the boiler fires but when i release it shuts off where is the ntc thing
ive bypassed that by linking wires still the same
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
