Velux window leak

No this is the side of window, the top has a good distance from the top of the tiles
That's good, but how will the water flow from the back of the skylight , and down the side if there is no 15-20 mm gap for drainage, as per velux instructions, you can't mastic everything together. I also suspect the soakers haven't been installed correctly.
 
Last edited:
Once it gets between the seals it flows down to the lock....and through the cut out, get some dye and trace the path.
 
I have just inspected the underside of the eaves after removing silicone under flashing etc, the left side I can’t see a drip no more but the right side is still soaking into the beam, I have lifted this corners flashing kit quite high to see underneath and it looks like where the tiles go under the kit they stop at the window frame but you can actually see the wooden frame underneath with like a 20mm gap between the frame and the tiles also goes up too like this, is this correct or has been incorrect since the day it was installed?
 

Attachments

  • image.jpg
    image.jpg
    691 KB · Views: 9
At least one side trim isn't fitted correctly (catalad?)
Check trim screws are correct and tight
Spunk and damaged slates.....uuik
 
I have just inspected the underside of the eaves after removing silicone under flashing etc, the left side I can’t see a drip no more but the right side is still soaking into the beam, I have lifted this corners flashing kit quite high to see underneath and it looks like where the tiles go under the kit they stop at the window frame but you can actually see the wooden frame underneath wit
Just strip the offending side out, and see whats happening.
 
Just strip the offending side out, and see whats happening.
This weekend I’m going to take off the bottom apron and a few of the side flashing bits and take away some slates to see and repair some. Will I be able to take this off by undoing the screws on the top of the frame? Also what do I actually do when I lift and find water is obviously getting down this corner by tracking across, and there is no felt kit installed to direct it onto the felt instead of soaking the rafter?
 
I wouldn't start by taking off the bottom apron, if you look at the side of the frame, there is a long slender side channel that is held on with 3/4 screws, once this is off it will reveal the soakers, there should be one for every slate, and should over lap each other by 3" or so. Check this first, if they all look ok, remove the tile highest up that side of the skylight, once that is removed it should reveal a metal soaker, once you take that off, it should then reveal the fixing for the next slate. Work your way down if need be, to the bottom apron.
 

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top