I've attached a photo of my slotted waste. I just want to check I've got the order, and orientation correct:
The basin itself would be between the black plastic 'washer?' and the soft, conical rubber seal.
Is this what you would expect? The problem is, I am getting a leak from the overflow. It doesn't surprise me as when you look through the overflow pipe into the slotted waste, half the water is going to go down the outside of the threads. Hence why I'm checking to see if I've got the washers, seals and nuts in the right order.
I've read lots of people suggesting a Basin Mate, but looking at what my basin and waste came with it is very similar so though perhaps this was a case of a bad workman and not his tools!
The basin itself would be between the black plastic 'washer?' and the soft, conical rubber seal.
Is this what you would expect? The problem is, I am getting a leak from the overflow. It doesn't surprise me as when you look through the overflow pipe into the slotted waste, half the water is going to go down the outside of the threads. Hence why I'm checking to see if I've got the washers, seals and nuts in the right order.
I've read lots of people suggesting a Basin Mate, but looking at what my basin and waste came with it is very similar so though perhaps this was a case of a bad workman and not his tools!