What sort of flex to wire LED downlights in serial?

[SmileyDan]

According to the manual for my Aurora LED downlights I need to wire the downlighters in serial. This is fine.

But what sort of wire/flex? I only need one wire from +ve to -ve of each light on the loop. Therefore is 2-core a wasted core?

 

[securespark]

It should say. What is the part number for the driver?

Can you scan and post the instructions?

 

[SmileyDan]

AU-LED16T

Ignore me... I mispoke and was referring to the lower powered driver re. wiring in serial. Turns out this new one has three outputs so can be wired in parallel. That means I can use two core I guess...

Still doesn't say the cable requirements though...

 

[Taylortwocities]

The AU-LED16T is a constant voltage driver so thye light (surely) would be in parallel? Why don't you read the instructions.... http://database.aurora.eu.com/GetImage.ashx?Type=InstructionLeaflet&Image=AU-LED16T_IP_V2_06.pdf

What are the wattage of the lamps, not more than 11W I guess, so 1mm cable will be plenty big enough.

Make sure you get the polarity right. Again, RTFM!