That sounds like a plan. Just one thing though: To get to pipe 1, your new drain will have to cross pipe 2. Have you checked the depths? 
Where to run waste in this pic?
- Thread starter hudster
- Start date
Sponsored Links
Actually I was going to cross it above ground (with the stub directly on top of where pipe 1 currently ends). But I could now in theory remove pipe 2 if I needed to - it's been blocked & covered in paving for over 30 years
I'd remove pipe 2, it doesnt serve a purpose, but be very careful as not to disturb the junction where it joins the live drain. Be wise to seal it off with a decent lump of concrete whilst you have it exposed, it'll ensure rats dont decide to use it as an escape route at any point in the future.....
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
