Hi all,
I'd like to wire my kitchen cabinet led strip lights in a way that allows me to to control them from a dimmer switch on the wall. My plan is to wire in another dimmer from the kitchen light/downstairs lighting circuit, then run the switched live and neutral into a MF junction box and from there take individual feeds to led drivers that will sit under each cabinet cluster. This way they all dim together and can be operated off a single dimmer. I'll use 1mm t&e cable to run from the jb to each driver, through chases ill cut out in the plaster board before the units are put up.
Id appreciate it if someone could sense check my approach and confirm that my it is acceptable or a better approach could be found? Also is it safe to wire straight to an led driver or should I terminate each cable from the jb into another jb and then connect that to the driver?
I'd like to wire my kitchen cabinet led strip lights in a way that allows me to to control them from a dimmer switch on the wall. My plan is to wire in another dimmer from the kitchen light/downstairs lighting circuit, then run the switched live and neutral into a MF junction box and from there take individual feeds to led drivers that will sit under each cabinet cluster. This way they all dim together and can be operated off a single dimmer. I'll use 1mm t&e cable to run from the jb to each driver, through chases ill cut out in the plaster board before the units are put up.
Id appreciate it if someone could sense check my approach and confirm that my it is acceptable or a better approach could be found? Also is it safe to wire straight to an led driver or should I terminate each cable from the jb into another jb and then connect that to the driver?
Last edited: