Hello all, my Worcester 24i has just given up the ghost completely this morning! Pump is working when both water and heating is turned on but little else is happening, i.e no ignition. So far, by using the fault finder in the manual, i have:
Checked the flow switch - ok
Checked the air pressure switch - ok
Checked that there is power to the fan and there isn't
Checked there is power to the board
The main LED is on, the reset switch is down and i can't see anything burnt out or broken on the circuit board.
Before i buy a new one, is there anything else i should be looking at other than what i've already mentioned?
Any help would be appreciated as it's bloody freezing here oop north!
Thanks
Steve
Checked the flow switch - ok
Checked the air pressure switch - ok
Checked that there is power to the fan and there isn't
Checked there is power to the board
The main LED is on, the reset switch is down and i can't see anything burnt out or broken on the circuit board.
Before i buy a new one, is there anything else i should be looking at other than what i've already mentioned?
Any help would be appreciated as it's bloody freezing here oop north!
Thanks
Steve