Hi all got a problem with my combi.
getting no flame, i've got a slow flashing radiator light on the front of the boiler, ignition is working getting a good spark. I have found the installation and servicing manual and gone through the procedure but i am not sure at this part, it states remove st 16 connector and test resistance of the contacts of 7 and 8 the brown wires and 9 and 10 (violet wires), are both reading below 100 ohms.
when it says contacts does this mean the contacts on the circuit board or the actual wires themselves which would be testing the gas valve windings.
if its the latter then im going to need a corgi fitter.
thanks
getting no flame, i've got a slow flashing radiator light on the front of the boiler, ignition is working getting a good spark. I have found the installation and servicing manual and gone through the procedure but i am not sure at this part, it states remove st 16 connector and test resistance of the contacts of 7 and 8 the brown wires and 9 and 10 (violet wires), are both reading below 100 ohms.
when it says contacts does this mean the contacts on the circuit board or the actual wires themselves which would be testing the gas valve windings.
if its the latter then im going to need a corgi fitter.
thanks