Fitting a worktop for a neighbour today as part of fitting a used kitchen on a tight budget.
He has picked up some suitable worktop off cuts.
Worktop is 22mm square edge. There will be a corner joint.
The fact it is square edge, does it need a joining strip?
He also got some end trim, so I am thinking to trim the cut edge and just butt with a plate or two underneath to hold the two together.
He has almost no tools. I do not have a router.
Don't think getting a pro in to do a proper mitre joint will be an option.
Any tip or better ways of doing this please?
He has picked up some suitable worktop off cuts.
Worktop is 22mm square edge. There will be a corner joint.
The fact it is square edge, does it need a joining strip?
He also got some end trim, so I am thinking to trim the cut edge and just butt with a plate or two underneath to hold the two together.
He has almost no tools. I do not have a router.
Don't think getting a pro in to do a proper mitre joint will be an option.
Any tip or better ways of doing this please?