HELP please can someone tell me what went wrong?
see picture at http://i57.photobucket.com/albums/g209/jaykay2_photos/90d33e6c.jpg
and
http://i57.photobucket.com/albums/g209/jaykay2_photos/DSCF1635.jpg
cut the female joint with the jig & router on the right hand top, then laid it over the left hand board as the walls were out of square, & scribed the joint, then overlayed the jig on the scribe line with the allowance for bush guide etc. my problem is that the left hand worktop is now cut to exact length from the one on it's left, i do have 26cm to spare on the other end of the right hand worktop, so question is can i move it up & redo the female cut, or is all lost?
HELP!!
cheers for reading this tale of woe
john k
p.s. the joint in terms of fit is the best one i have cut sofar!!
see picture at http://i57.photobucket.com/albums/g209/jaykay2_photos/90d33e6c.jpg
and
http://i57.photobucket.com/albums/g209/jaykay2_photos/DSCF1635.jpg
cut the female joint with the jig & router on the right hand top, then laid it over the left hand board as the walls were out of square, & scribed the joint, then overlayed the jig on the scribe line with the allowance for bush guide etc. my problem is that the left hand worktop is now cut to exact length from the one on it's left, i do have 26cm to spare on the other end of the right hand worktop, so question is can i move it up & redo the female cut, or is all lost?
HELP!!
cheers for reading this tale of woe
john k
p.s. the joint in terms of fit is the best one i have cut sofar!!