OK, so my TEKA extractor hood stopped working. I'm no expert but I pulled out the PCB and saw that the circuit board had blown.
I think I have also found a replacement part but I'm a bit worried. The wiring coming into the PCB isn't in a handy plug - it is all soldered onto the board. This would be a job beyond me. Surely it shouldn't be that hard, and I am missing something. The board blew once before when it was under warranty, and a engineer replaced it. I don't remember him doing any soldering.
As you can see from the pictures, the cables disappear into the unit.
Any help greatly appreciated!
Thanks!
I think I have also found a replacement part but I'm a bit worried. The wiring coming into the PCB isn't in a handy plug - it is all soldered onto the board. This would be a job beyond me. Surely it shouldn't be that hard, and I am missing something. The board blew once before when it was under warranty, and a engineer replaced it. I don't remember him doing any soldering.
As you can see from the pictures, the cables disappear into the unit.
Any help greatly appreciated!
Thanks!