While searching for a swivel type radiator connection I came across a website called Rotarad who make a product found her on Screwfix.
I am trying to make a hot water laundry dryer from a large ladder rack towel rail and needed the rail to swing down away from the wall to about 20-30 degrees to allow towels etc to hang vertically from the "rungs".
These fittings are designed for maintenance cleaning and decorating which I suspect is only two or three times per year. However my intended use might be rotation two or three times per week during the winter.
Does anyone have any experience of fitting these? If not does anyone know of a swivel type 1/2" fitting that I could use like these for instance which sadly are only available in the USA. I could use the flexible tails used in plinth heaters like these but they are a bit long and many heating engineers have been pretty scathing on this forum when flexible hoses have been suggested before in HW CH systems
Fozzie
I am trying to make a hot water laundry dryer from a large ladder rack towel rail and needed the rail to swing down away from the wall to about 20-30 degrees to allow towels etc to hang vertically from the "rungs".
These fittings are designed for maintenance cleaning and decorating which I suspect is only two or three times per year. However my intended use might be rotation two or three times per week during the winter.
Does anyone have any experience of fitting these? If not does anyone know of a swivel type 1/2" fitting that I could use like these for instance which sadly are only available in the USA. I could use the flexible tails used in plinth heaters like these but they are a bit long and many heating engineers have been pretty scathing on this forum when flexible hoses have been suggested before in HW CH systems
Fozzie