Gutter issues

Joined
22 Nov 2018
Messages
1,581
Reaction score
26
Country
United Kingdom
View attachment 225149 After lowering the top of this downpipe in red on fascia the downpipe part (in purple) leaks water on joins and the water runs down the outside of it. I wrapped that plumbers tape around it but didnt seem to work when I tested it straight after. The tape looks ridiculous too.
Any ideas how to stop this?

View attachment 225147 View attachment 225148
 
Last edited:
Sponsored Links
the offset bend is upside down..
Thxs lol. I did turn it round that way because it was leaking the same when the other way. Should gutter name etc go on bottom ? Would new downpipe and offset bend sort issue?

Is it to do with shape of guttering and they'd be less leaks if round?
 
Sponsored Links
Yes, as suggested that bend is the wrong way around.
As it was leaking fitted the correct way, buy a new one and refit using some exterior gutter sealant.
Of course the correct way around.
 
Can't see why it would leak if elbows are correct way around unless it's backing up.
 
Yes, as suggested that bend is the wrong way around.
As it was leaking fitted the correct way, buy a new one and refit using some exterior gutter sealant.
Of course the correct way around.
Get new one I guess.
Is the pipe blocked further down ?
No. I might try correct way again see if that that works. The gutter which downpipe slots into (on fascia) was lowered by 10mm. Another possibility is there is a crack on top of downpipe which slots into bottom of offset bend. Also maybe when it was correct way round the top wasn't in properly. No idea.

Out of interest, how do u know which is the correct way round , is writing at bottom?
 
Last edited:
Out of interest, how do u know which is the correct way round , is writing at bottom?

Correct way round. Male flows into female.

s-l400.jpg
 
Correct way round. Male flows into female.

s-l400.jpg


Right that makes sense. So switch just this little part of guttering (circled) around other way? I didn't switch that round before. That was always like that
20210305_000417.jpg
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top