Very smooth filler

[leej90]

Hi all

Can anyone recommend a filler for internal walls that can be sanded down to a very smooth printable surface.

I'm hoping there may be a trade product better than pollyfilla?

Thanks

 

[jacko555]

I use https://www.screwfix.com/p/toupret-fine-surface-filler-1-5kg/935jj

Stripped a wall, there was paint underneath that half came off. Looked like Tommy Lee Jones face.

Filled all the holes and scratches. Feathered edges.

Cannot tell. Great stuff. Only good for 1 or 2mm deep or it sinks, but, deeper holes require their normal filler.

Way better than cheap filler.

 

[opps]

It kinda depends on your tolerances.

The Toupret fillers are a cut above the likes of Tetrion or Polyfiller powder based fillers (in the main) but any filler that is slightly harder or softer than the existing emulsion will leave a dent or ridge.

I haven't used the particular filler recommended by Jacko though.

Part of the secret is using the right grade of abrasive. The mesh papers (eg Abranet) are often better than standard papers

 

[catlad]

I've used easyfill a few times.

 

[HERTS P&D]

This stuff:

https://www.toolstation.com/gyproc-...VWe7tCh2zQghvEAQYASABEgKxzvD_BwE&gclsrc=aw.ds

Andy

 

[opps]

I've used easyfill a few times.

I use Easifill from time to time but it is incredibly soft, ie not resistant to knocks. Very easy to sand though.