I've got square pipe sticking up from the ground, cemented in. And putting in new downpipe which I want to be round.
I've seen these square-to-round adapters which are always shown with the square bit at the top. I assume they can be used either way around, I wasn't sure if there might be a bit of a gap around the connection if I invert it?
Can I just one of these at just above ground level to go from round to square?
I've seen these square-to-round adapters which are always shown with the square bit at the top. I assume they can be used either way around, I wasn't sure if there might be a bit of a gap around the connection if I invert it?
Can I just one of these at just above ground level to go from round to square?