Thank you for all your help. I will have a look at that in the morning. Seems straight forward when you know how.
I was not even sure where to start.
Thanks again.
Will post when i have done it
I have a puegeot 306 1.4 xl
The water temp gauge does not work.
Also the heater gets a little warm but not hot.
I have told it could be the thermostat.
Can anyone please tell me where the thermostat is on this model
or any idea if its not the stat what the problem could be...
i have not had a chance to have a good look yet but looking on saniflow's site the pipe work for the waste is at low level on the unit. this one has a sink waste going in midway up is there some were lower down i can add the shower waste ?
can it be drilled and a fitting added ?
hi i have a toilet and a small hand basin going in to a saniflow.
i would like to know if i can add a shower to this set up.
the sink waste goes in to the saniflow half way up this is obviously to high for the shower,
any advice would be appreciated
thanks in advance
hi mark would it not be possible to use a combination of chasing the floor
and horizontal between sockets.
do you have the test equipment and can you complete a test certificate?
they can be downloaded free from the iet site. if you can do this you will have
no problem getting your...