Recent content by pipeslice

Many thanks for the reply andf advice,, Yes it will boot into safe mode, sometimes the screen goes blank with safe mode displayed in the 4 corners and some times it runs through list of programs maybe half way through before it stops. F8 i`ll be pressing that and off searching for the...

Hi Folks help needed, Last night while playing poker on my latop a message appeared to remind me about updating my anti virus which has now expired,, i clicked remind me later .A new message appeared then stating system failure and Trojan virus count to which the laptop started realling offf...

Yeah ,,, Circle yeah , up around and down. Is this the best way of doing it as i can`t move the cylinder or the stove

Hi Folks, bit of a tricky one here / Ground floor Cylinder 1st floor Log Burner 2nd floor f+e tank Can i run the log burner flow up to the 2nd floor complete with feed and expansion connections and then down to the cylinder and back up with the return to the log burner. Will this...

Hi folks bit of a problem with maxol , any help at all. Have just connected one up (existing) to a thermal store 170ltrs , but the boiler can only heat the vessel up to 55 deg with temp control up to max and then after half hour heat the burner shuts off on over heat but not tripped on the...

Jon26, Try McDonald Cylinders. There up your way

Hi folks looking for any advice. Recently i was asked to install a pellet burner and radiator/hot water system. Has any you folks any advice

Hi Folks Background 1 Home desk top computer cable connection 2 Laptap wireless 3 Bt home hub Problem is a short while ago my laptop did nit automatically connect to "Home Hub" i had to search for it auto` and select. However now my laptop cant even find the " Home hub" Have...

Will remove the wheel sun morn and give it a coat of looking at Thanks for the advice guys :D

Hi Folks advice needed Drivers side wheel has started to knock knock Only when driving over man holes , drain lids and low road works. No feeling on steering wheel only on re turning round round abouts L then R but have slight whinning from below Wat you guys think s wrong/broken/failed

My argument is that the old guy who trained me was coming up to 60yrs old he might well of been set in his ways but what ever he did or made me do his way never leaked and always circulated He never used plastic even till his time was up some 10yrs ago RIP Raymond All joints were solder ...