Recent content by prceramics

get him back an show him what you are talking about with the level? you might be too fussy mate , it might be a simple problem to overcome its hard to say without seeing it just remember your tiled surface will mirror your untiled walls

why did you plaster it? you should of just left the plasterboard far better surface to tile, if you are using adheisive to hide 10mm i feel you are asking for trouble

overboard with hardie backer-board trowel over flexy adhesive to fill the voids then screw the board down ( where to screw is marked on the boards) then tile and defects (bounce) in the floor must be sorted first

score the rectangle drill a hole in one corner then nibble the rest out with parrot pincher's

why not just recolour the grout ?

you should never tile onto tile .

preperation is everything in tiling get it all off mate

who told you that ?

batton the walls do the walls first apart from the bottom cut then do the floor then last wall cut

tape :)

you can use 3mm spacers on the floors mate but that is the Minimum

grout after 24hours unless says different on adhesive instuctions then you are suposed to wait 2 weeks before using the shower i take it is going to be tanked or have you used backerboards ?

good call was having trouble getting me head around it lol

have you looked into ditra matt its only 3mm thick or Durabase CI Matting

you could try this http://www.ebay.co.uk/itm/NEW-TOOL-MARKET-TILE-REMOVAL-TROWEL-NO-WALL-TILE-DAMAGE-/360443501478?pt=UK_Hand_Tools_Equipment&hash=item53ec1b5ba6 but i feel it would be quicker and proberly cheaper to change the board :)