Recent content by RepairingDave

Thanks. I've had a look at a couple. Unfortunately, the type I have are 'bottles' that "these no significant electronics or mechanical parts and no value once empty as they are just hoppers for toner powder"

The silly question first: Have you got a thermostat and was it turned up far enough to make the boiler turn on? Also, does the heating come on when both the hot water and heating is turned on?

Unfortunately, the nearest recycling centre that accepts them is 15 miles in a direction I don't often travel!

The 2 satellite cables (164702) are for a box with 2 tuners so that you can watch one channel and record another (or record 2 different channels).

From the first 2 photos it looks as though you might have wound it round in the wrong direction. If you can push the line all the way through then you need have the spool half way along and then wrap the line around - one to the top and one to the bottom following the slots.

What about a course of concrete commons along the top?

If they are the lightweight thermal/aerated blocks then drill them with the hammer function turned off. If you used concrete screws then you wouldn't need plugs.

I don't know what happens any waste toner, but I don't that there is any as it just looks like a plastic bottle which is shaped to allow it to be twisted by the photocopier. They are this type...

I managed to do it a couple of times with an Epson printer. and also redirected the pipe from the printer heads to a bottle rather that the waste ink pad. - The first time I paid a service center to reset it, but they refused to do it a second time. If the printer won't let you print and you...

I was wondering if anyone knows what to I should do with an toner cartridge or 3? I have been advised my current supplier to put them in the 'normal' bin (which was vague). As they are made out of recyclable plastic (PET) I feel that they should be recycled or refilled. If I were to put...

It is a USB A integrated into the receiver. I understand what you are saying about the power supply vs charger. I wanted Bluetooth receiver because I've got a Bluetooth transmitter & receiver and I have to change over to receive every time I switch it on. I thought it would be a simple case...

They are they type that plug straight into the USB socket. I tried without a usb extension in case that was the problem.

I've brought a couple or Bluetooth receivers which are usb powered. It was impossible to get them working at first. I eventually got them working, but with a different usb socket - the same or lower ampage rating. Does anyone have any idea what is going on here?

3foot could easily be the height of the original opening. What is your end goal? These websites might help: https://stovefitterswarehouse.co.uk/pages/introduction-2 Or https://www.homebuilding.co.uk/advice/how-to-remove-a-chimney-breast

How high above the floor did you start? It looks like there is modern cement on the bottom half, so maybe it was taken out when work was done previously..