What foam gun?
- Thread starter bilabonic
- Start date
It is normally acetone.
I'll be using it regularly For new door frames tbh.
Plus any other holes I can find.
But again the end of the nozzle where it exits is exposed and will expand/harden?
That was my point sorry.
I premed it had to be flushed out after each use.
Or I was going to cap off/tape the end so it's not exposed.
Thanks for the advice.
Plus any other holes I can find.
But again the end of the nozzle where it exits is exposed and will expand/harden?
That was my point sorry.
I premed it had to be flushed out after each use.
Or I was going to cap off/tape the end so it's not exposed.
Thanks for the advice.
You can spray some of the acetone cleaner on the end of the nozzle to clean it.
This may not be needed, if you scrape off the foam when you next use it.
You don’t need to ‘flush’ it
Awesome.
After years of using canned stuff with screw on plastic tubes this ses
The way forward.
Just got googled now what the end twist/adjustable cap is for?
Allow a certain amount of air in I presume?
Leave it open or closed after use?
There again if it's not been mentioned it. Ants do much...
After years of using canned stuff with screw on plastic tubes this ses
The way forward.
Just got googled now what the end twist/adjustable cap is for?
Allow a certain amount of air in I presume?
Leave it open or closed after use?
There again if it's not been mentioned it. Ants do much...
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
