Search results

Gone for a Durafix drill driver and will use corded hammer drill alongside. Will be looking for cordless hammer drill next month

Looking for your suggestions - I'm fixing both plasterboard to timber studs and ply sheathing to concrete base. Looking to purchase either a Drill Driver or maybe Impact Driver. Suggestions please. Thx

Not sure but we reckon he should be sealing the floor with some sort of dpm resin as I can't see the point of a plastic DPM which would be compromised by the ply being fixed through this to the base.

Any recommendations for on-line sales of Oak, Maple solid wood flooring or indeed those to avoid?

What type of fixing wouod you recommend for fixing the ply to the concrete floor, taking into account it's 4mx3M in area?

Just spoke to my Joiner who tells me Elastilon is a non-starter for this type of floor.He intends to glue and pin to ply subfloor.

Was reviewing Florence Solid Rustic Oak Flooring 120mm Width Lacquered is 120mm wide, 18mm in thickness and comes in random lengths of between 400mm - 1500mm. From your info of your website are you advising that it would be better to have a similar plank, 120mm wide, 18mm in thickness. which...

Thanks for the in WYL, taking a look at web site now. Presumably if we go down the Elastilon route the floor is of a floating mode?

I'm in the process of information gathering on putting a new oak strip floor down in a ground floor room, 3 metres by 4 metres, which has a concrete base. The Oak is 120mm wide, random lengths and 18mm deep. It has been suggested that the best method to install it would be to fix a base of 18mm...

I'll check flow/minute again this evening, what should we consider as a reasonable flow?

Yes I meant flow, next door neighbour is an Instrument Engineer and borrowed a simple looking flowmeter from his co workshop

We have finally chosen to go with a Worcester Bosch Greenstar condensing boiler. We have an incoming water pressure of 14 litres/minute max. Can anyone tell me whether we go for the Greenstar 30 Si or Greenstar 30 CDi series, pro's and cons?

Come on people ! There must be someone on this forum experienced enough to sing the praises or shout at the failures of any of these 3 pieces of kit I've asked about.

Have been quoted Sime Murelle 30 HE which isn't in favour by most on this forum. So, what are the comparables offered from Worcestor-Bosch and Vaillant for the equivalent output the Sime provides?

Just received a more reasonable quote for our ongoing Combi installation exercise, however, the piece of kit being suggested is Sime Murelle 30 HE. Any comments or opinions on how this ranks performance-wise against Vaillant ecoTec Pro 28 or Worcester 27cdi and operational differences?

We're in Preston Lancashire. Been quoted 2 prices over £4k! Reckon somewhere around the £2k mark more realistic

How much should we be budgeting for supply and fit of a new combi boiler, Worcester or Vaillant, plus associated powerflush etc?

Thanks re Sime, just reviewed a few posts and there's a lot about leak problems with Sime's. Any more suggestions/recommendations on similar combi's to the Vaillant and Worcester?

Thanks for the response, much appreciated. I have another couple of quotes to come in and no doubt questions to ask if alternative models are suggested. BTW was talking to the local plumbers merchant this morning and he was recommending Sime combi's, never heard of these and Broag

Anyone care to comment on the pro's and cons of these 2 combi boiler's that I've been recommended?