Search results

Hi i have just had a new roof finished today and before i pay i would like a roofers opinion about the way the lead is finished near the chimney and the the bonding gutter Mine is the roof with the aerial thanks

Anyone know the difference or opinions between these two models thanks

Thanks .Just helped me decide I have some spare tiles I will take a couple off and patch up as needed after getting pipes in Never thought of going through the other side but to be honest that would be a job as well to finish off with what would be needed

I want to install a mixer shower ( mira atom) I need advice on the best way to tackle it see photos I dont really want to remove any tiles if possible because they are stuck onto lath and plaster I have some room under the bath as can be seen but which way to route the hot and cold (n) any...

I have a ideal logic c30 a year old and would like to put in a mira atom mixer shower I normally have the hot water set to 58deg Would it need uping to maximum for a decent shower and is the boiler and mixer a good " match" thanks

thanks i reckon i can do that

Hi can i change the washers without turning the water off on this tap I have no isolating valves in the bathroom and i didnt want to mess with my new combi boiler thanks

thank you i understand

I was also made aware that the dividing boundry line is over my side with there tiles I have never noticed with " senior" eyesight How do you resolve that What a mess .I am bl00dy mad about it

My neighbours roof was renewed some years ago and were it joins mine it hasnt got a roof drainage channel in between just cemented at the joining tiles He had leaks there this week and a roofer told him what was wrong and told me the water has made some of my wooden lats go rotten My roof is...

thanks

LOL

Is this the right procedure When i replace the Rad I turn on just one side and fill the rad at the same time undo the bleed valve until all air is dispelled then turn on the other side After this re pressure the sealed combi system thanks

Do i nail ,screw or stick the MDF to the wood battens Thanks

Thanks chaps I am going with the mdf I can get good straight cuts out of a sheet at BQ but not champered im reckoning

I have just had new heating put in and i need to cover these pipes I am at a loss what to use to box them in Hardboard ,mdf , Any suggestions that will make it look aesthetically pleasing As you can see it goes through the coving dado rail and skirting I have the wallpaper but wondered on a...

how long do i leave the bonding before i finish up with multi finish thanks

I have a chimney breast opening i am blocking off Its all plaster board but one area about 8"x 4" is lower by about 9mm Am i best doing that part with bonding and the rest with multi O r could i just use one of them Area to be covered 3 ft. square

My pilot light on the boiler wouldnt stay on ,so i replaced the thermocouple Now the pilot stays on fine Just when i turn the boiler on it runs fine for about 20 seconds and then cuts out along with the pilot light Any suggestions please , we are talking gas now so i wont be trying anything...

I have drilled 6 8mm holes and put in rawplugs for that size supplied and inserted screw type bolts supplied to hold a wall mounted tv plate Thing i cant tighten up firmly because the blocks are so soft Any suggestions please