Search results

  1. A

    EV Charger into CU or Direct

    Hi all, I've got a Rolec WallPod Type 1 charger (J1772 i think the model is) that has it's own RCD (not sure what type) and i'm going to get it installed on the wall outside which has my external electrical (incoming) meter box on and on the inside of that wall is my CU so although i'm going...
  2. A

    Best glue for a Vinyl flooring tear

    Hi all, Anyone recommend a really good glue for Vinyl sheet flooring to wooden floorboards ? I'm laying some for my Daughter and accidentaly ripped it and it's quite a long rip (about 12 inches) but luckily it's not in a high footfall area. I don't need a lot i don't think so a tube would be...
  3. A

    Widening an old fireplace with a 45 degree chimney

    Hi all, I've got an old dis-used fireplace on the kitchen that I'm hoping to get widened to fit an American sized fridge freezer as it's currently just dead space. The wall WAS boarded up in some old cladding and so I've taken that off to see what the arrangement was behind it and i thought it...
  4. A

    Is this CU correct?

    Hi all, I've had a look inside my consumer unit (picture below) and it looks like there are 2 RCCB's in there but there's one at either end but on doing some investigation i get the impression that these should have the fuses that they protect on the left or right but on mine there are 8...
  5. A

    Can i use Black Jack Bitumen to seal leaking concrete floor?

    Hi all, I've got an old sectional concrete panel garage with a concrete floor that i have a small area on (about a foot wide) that is constantly damp and sometimes has water on it. I can't see that it's coming in through the walls but i can't see any "obvious" cracks in there and it's not...
  6. A

    Mastic or Cement on Pre Cast Concrete gaps

    Hi all, I've got one of the old pre case panel type garage that lets in water through the slight gaps between the bottom of the panels and the floor base however this is only on one end and this is because the garden at that end is higher than the join by about a foot so when it rains the water...
  7. A

    Can i cut 80mm hole in teracotta drain ?

    Hi all, I've got an 80mm french drain to put in my garden and need to connect it into my water drain but the trap drain that i need to connect it to is an older square terracota one. I can obviously dig it all out and replace it with a plastic one but i wondered if anyone had ever managed to...
  8. A

    Lower main avenue drain cover

    Hi all, i've got a drain cover (as per the picture below...obviously taken off) that is sat smack bang in the middle of our walkway between the house and the garden. This is the main drain that runs through all the houses on the road and although the picture doesn't show it the cover is a layer...
  9. A

    Emulsion or Masonry Paint on OSB3

    Hi all, I've read quite a few posts and recommendations for painting OSB3 but the cost of what is recommended make a Latex/Acrylic based paint a massive cost hike for us but a lot of people/posts around states they have painted using masonry paint but others said not to use a water based paint...
  10. A

    Onduline roofing sheets leaking

    Hi all, I put Onduline bitumen roofing sheets on my garage this year (about 8 months ago) and it's constantly leaking. I've overlapped the sheets fine but there are massive patches of wet on the underside of the sheets i.e there's not a few leaks where it's dripping out of a 1cm wide gap or...
  11. A

    Shower Pan with Cement Fibre Board

    Hi all, I fitted a shower into my bathroom when I renovated it just over a year ago and due to where the drain pipe from the shower tray is I've had to buy a raised shower tray but have found that it's cracked and looking at the reviews (ironically AFTER the warranty ran out) I see loads of...
  12. A

    2 Radiators not getting hot

    Hi all, We've got 7 radiators on our house and I've gone to bleed them today and found 2 of them are not even getting warm. One of these is downstairs and one is upstairs. I've bled them both and i can feel the pipe going to the non-TRV valve (i.e the one with the white cap on it) is hot but...
  13. A

    Building Control - Electrics done myself

    Hi all, We've built a new extension and building control have said that as we've kept the exterior wall and door in place (as it's just a larger replacement of an old conservatory) that we won't need building control as such and they're happy to sign it off however I want 2 x 2 Gang electrical...
  14. A

    removal of garage door

    Hi all, How do i remove the spring on this door assembly ? i can see a socket on the left of the spring but it looks different to any on the videos i've seen, it seems to have an allen key grub screw on the top and bottom and the 4 holes on the sides so am i to put a screwdriver in two of these...
  15. A

    Anyone used anti-slip decking paint ?

    As the title says, going to be putting decking down and wondered if anyone has had any real-life experiences with this stuff ? i.e does it actually stop slipping when wet ? Also would we stain the decking as normal and then this goes on after in which case is there anything we can put on to...
  16. A

    Do i need battens on top of Cement Fibre board

    Hi all, Might sound a stupid question but....got an exterior building covered in Cement Fibre board that we are unsure as to whether to render it or clad it in wood at the moment but normally if you've got a wooden OSB wall (which this has) then you'd put battens on to raise the wooden cladding...
  17. A

    Render on top of Acrylic Primer on Cement Board

    Hi all, We've put Cement Fibre board on the outside of a room/building we've built and i was hoping to simply prime and paint it if i could get it nice and smooth but as i didn't realise how difficult this stuff is to cut and shape it's not turned out perfectly well so i've put Leyland Acrylic...
  18. A

    Decking risers without concrete footings

    Hi all, Going to put decking down around my extension and although I've seen them before I've been looking at the decking risers (i.e the plastic circular feet) and looking at a couple of suppliers they are saying that there's no need for concrete footings for these and you can put them...
  19. A

    How to make elevation plans

    Hi all, I'm a home owner (not professional builder) and i need to create an elevation drawing for building planning so any advice on what to use to make this ? i.e can i simply draw it by hand or use something like Microsoft Visio or something ? Never had to do one before so not sure on how...
  20. A

    Cement Board Joins and Caulking

    Hi all, Two questions for this...i'm putting Cement Fibre board as an external protection\clad onto a small building and as we can simply prime it and paint it (as opposed to putting a render or further cladding on it) i've never installed this stuff but looking at various instructions and...
Back
Top