Search results

Yes it’s a large house build in 2002 and plumbing done professionally at that same time. So the purpose of that pump is to get instant hot water ....yes. Because each boiler has got their own circulating pumps Thank you

Circulating pump just for hot water ?

Hello and good morning, hope someone can or knows what this pump on my system do and how, please look the enclosed photos The plumbing on my house has been done around 2002 , it has 2 conventional Alpha boiler next to each other ,I have no problems at all for now with the system. What puzle...

It has been flushed twice since installed ???

Yes it was the plate blocked, Worcester engineer came today and replace it. Thank all for the input

It was purchased on a benefit scheme

Will it be cleaned with in the boiler or has to be removed from system, and what is the average price to unblock it

expired 2nd Jan 2021 55708590025377733600005

Not been very lucky with the above boiler and supposed to be one of the best for the money I paid for. Fitted Jan 2019, just before the year warrant expires the boiler start leaking around the heater exchange and was repaired by Worcester engineer under warranty. Today DHW problem, CH is fine...

Will get someone to investigate Thank you for your input

Hello, I suspect my existing RCB defective and would like to replace it, its a 100A LN7700 But I got the feeling its discontinued. With what can I replace it, it,s on a 14 way CU Thanks if you can advise

Hello, I'm converting a double garage to annex , these garages have 2 doors about 2m x 2m and both motorized..... stop me now if I am in the wrong section. Those door are GRP material and each have a Cardale DC-650N motorized unit. I have now build a separate garage 3,7m x 2.2m GRP tracked...

My contractor are going to plasterboard the ceiling of my garage and the rsj in the midle of the garage is flash to ceiling joist. The loft above the carage ceiling will have insulation between joist Is it normal for the plasterboard to touch te rsj or should it be a gap ? I'm concerned about...

So all I have to do is remove the cap and fit an other element of course after bleeding the system, yes ? This is an inderect water cylinder

Hello there , I have the immersion heater installed on the first floor it was already there when i bought the house, it has been workin fine for the last 11 years and still working good up to now. My question is there is only one element fitted and connected at the bottom but at the top there is...

Redland Mockbont 10 slates

Redland mockbond 10 slate

Today I had a roof man to do a roof on my garage wich is 6000 x 5000. He did a roof type Vaulted roof with a ridge beam , so no strut Is this ok, the roof angle is 20 degree. Thank you