Search results

Hi Guys I have installed a Crosswater shower like this item https://www.taps4less.com/PP/CW-PRO2001RV.html?source=aw&aw_affid=531573&awc=102985_1764107944_d509d16f4b55e4134591ee8473a091f5 Customer called tonite saying she turned the hot water on and it wouldn't turn off, I was just setting g...

Hi Guys I have been tasked with sourcing some water heaters to be used in various function rooms, I have unvented ticket but have never installed or had any dealings in water heaters. Any advice or guidance is appreciated. 1, clinical room basin, this will be located in the adjoining room on...

Hi Guys, Got a job for a LL in an air b&b, heating system is shared over a flat upstairs and a flat downstairs, currently there's a gate valve used as a bypass, they're complaining that rads near cylinder are getting hot, when I got there the cylinder stat was at 70°c and the gate valve was...

Hi Guys I have a job coming up, kitchen sink to do with a waste that is quite high, looking for options, there is also a washer and dishwasher to contend with, I'm hoping the picture is deceiving and it's not as close as it looks. If anyone has any suggestions they are welcome, one thing I do...

Hi Guys The sparky has wired up a y plan for me ( all new stuff, and the on heating the boiler and pump only power up for 2 seconds at the most whilst the valve is moving then go off once it's done moving, any ideas s to the problem, he may not be there when I go back and would like to fix it to...

Hi Guys, I hhave to brick up a flue and have managed to match the bricks but wouldn't know where to start with matching the cement, could you please advise as I have no clue where to start with this colour, it looks like there's a red or pink coloured sand in it Cheers

Hi guys Im really hoping somone can assist us in this issue, we are to swap some damaged slabs that were damaged during a tree falling over, we are to swap approx 12 slabs but are really struggling to locate some but the slabs in the correct size (850mm x 560mm) seem unattainable. Hopefully...

Hi guys I am in a bit of a situation, our joiner has installed a kitchen and there's a drawer unit and fillet piece to the wall there is 60mm clearance between wall and edge of the drawers, I have been looking at the following options 1-an old type radiator 600mm high x 400mm wide with no...

Hi Guys Currently working on a school and the service trenches flooded due to burst pipe so we are removing the vinyl and all associated timber and replacing with new on a like for like basis, around 10 years ago the last contractor removed all the access hatches (Nice heavy duty brass ones)...

Hi guys I have knocked through my hallway wall into the garage and in the process of installing a fire door, I have the door 762mm (30") wide fd30 and a rebated fire rated frame and strips also rated self closing hinges, just after some advice on what to set my frame width at and how much space...

Hi guys Today's project has turned into a can of worms lol I broke a tile and a ridge tile and struggling to Identify them, my neighbour says he thinks they are a marley but he's not sure, hopefully someone on here can help me identify them Regards

Hi guys I'm just redoing my fascias and soffit and decided to go for the above mentioned caps over my cemented verge, I have cut back my tiles by 30mm to allow the trim to sit flush and reading some instructions it says to remove all old mortar, my question is is this necessary? Can it be left...

Hi guys I have had the house 3 years and finally got round to this job, I have been avoiding it and now it's time to sort it. the house is approx 27 years old and the 2 concrete lintels that support the inner and outer skin of the front of the house is in my opinion very inadequately supported...

hi guys if you had to design a heating system what software would you use? I have seen some done by you guys in the past posted on here and could do with one right now regards

hi guys just tiling my bathroom at home, the wife chose these tiles https://www.wickes.co.uk/Wickes-Olympia-Grey-Polished-Sandstone-Porcelain-Wall+Floor-Tile---600-x-300mm/p/213367 tried 2 different manual cutters and they cut short ways successfully 2 out of 4 tries and long ways no chance...

hi guys I bought one of these a few years ago and come to use it and tubes have smashed, does anyone know where I can obtain replacement tubes as internet searches have got me nowhere regards rich.

hi guys just buying in process of buying house and seeing how far our budget will get us, and going to do facelift straight away e.g. new Windows door and fascia n soffets and gutters n pipes etc and at same time we are looking at putting an extension on front of house single storey only...

Hi guys just doing my shed with these sheets and wanted black but could only get hold of green so thought I'd paint them black, what would you guys recommend I use? Regards Rich.

hi guys i inherited this laptop and it has high sentimental value rather than financial, since taking ownership of it i have used it once and it worked like a dream this was 7 days ago and i turned it on today for the wife and it booted up and said something like windows update installing, then...

hi guys im wanting an a4 printer for van to work in conjunction with my galaxy s2 phone to print invoices off for customers, my phone has wifi and bluetooth and pronter can be 230v as i have an inverter any advice would be apprechiated cheers RIch