Search results

I have had a Balanced Flue gas fire removed ( Gas Safe) there’s no Chimney , just the pre-cast opening and the stainless flue. As I am replacing this with a media wall & electric fire should I block up the opening, given that there’s no chimney involved ?

I had to replace one of the sealed units on a small opening unit of a conservatory. Due to the age of the conservatory, one of the beads was brittle and broke. The conservatory was installed by Anglian windows around 1998 and is externally glazed - can anyone identify the profile please?

Currently have the above with a Fluidmaster Valve & a Ideal Standard Flush Plate .I replaced the valve as the flush is quite difficult to operate & also replaced the air pipe but the problem remains has anyone a recommendation to replace the (9"x6") Flush panel or should I try a different...

Can someone recommend a good brand of concealed flush, I replaced the existing one with a Macdee unit but the flush is still poor - The water level is fine, the pneumatic air tubes are new and not too long.

Can the bearings I in an AEG Lavamat L14510V1 (Type P6498449) be replaced and how difficult a job is it in this particular model.

Can anyone suggest what might be causing the above, It's not a Kettling sound - it's more like an asthmatic Parrot! It's has only just started a couple of days ago other than that the Boiler is working fine . ( A Powerflush was carried out about 5 weeks ago)

Whilst I appreciate these are the worst boilers made I have one which is used to heat a Koi pond via a Heat Exchanger and at the moment I can't afford to replace it. The problem is that whist it fires up it for about 2 mins then shuts down. The fan works, boiler fires up and gets hot but no heat...

Ok so here we go , system is a conventional Ideal Classic Boiler ( Downstairs) with open vented system. No problem until this winter and only the upstairs would warm up then hot water was tepid. Motorised valve replaced and hot water back to normal, Bleeding radiators got to be a daily...

The oven light blew last night, so I have replaced the bulb - everything works except the oven light will not turn off!. I have tried powering off for 10 mins then re-setting the clock but still it doesn't turn off. The Cooker is a Siemens HB750550B

A friend had his central heating pump pack up - the plumber said that he is not allowed to replace the existing Grunfoss pump with an identical one . He states that the EU regulations require him to fit an Eco 'A' rated pump is this correct?

I am thinking of having my Ideal Classic RS60 (Wall mounted) boiler replaced for something more economical and wondered what your suggestions for a replacement would be ? We do want to keep the hot water cylinder rather than use a combi.

Can someone tell why my Ideal Isar is showing 'p' in the display ?. I have tried switching it off and back on but it still shows 'p'

Can someone suggest a good brand of wire strippers that won't go blunt or break in a couple of months!!

Can anyone suggest what the fault is on the above. The central heating is fine, but when hot water is called for the boiler fires up hw pipe at boiler end gets hot, but then shuts down after about 10/15 seconds.

Since our area went digital(Belmont) about 3 weeks ago I have a problem with my newest TV .The set is a Philips 26PFL 7532D . I receive about 105 chanels, but when you switch the set off you have to reinstall everything again as it doesnt appear to store them When running is shows signal strenth...

I use an Ideal Icos HE24 for heating a Koi pond, recently the display died but the boiler continued to work fine.The fault was identified as a break in the circuit board where the purple wires connect. I obtained a second hand PCB (Black) which was installed but the boiler was dead. The old...

I have the above boiler which is working fine, except that the LED display panel has gone blank. First thought is to leave it alone, except that if it does develop a fault I will be unable to view any fault codes. Can someone point me in the right direction.

I am trying to find out what type of paint to use as I a have a number of Japanese StyleGarden ornaments around my pond including a bench. These are concrete and are finished in a Matt Jade Green. I thought of having a colour mixed in Smooth Masonary paint but have been advised that as...

I have a Kalavit Babel wc about 3 years old, and I require a new flush mechanism (single flush via top mounted button) can anyone tell me where I can obtain Kalavit spares from ?

Do I need to nail the Insulation Boards that I intend to fit under the Laminate Flooring. I have purchased them from B&Q but there appears to be no instructions