Search results

  1. P

    Moistsure Tile Backer

    Hi all, does anyone have any experience of using Moistsure Tile Backer? Apparently produced by Resistant, http://www.cwberry.com/Inquiry_ProductDetails.aspx?ItemNumber=02250385 I have used Aquapanel (Knauff if I recall correctly) in the past an found it to be an excellent product, but the...
  2. P

    Replacement Porch

    Hi all, well freddymercurystwin has kindly answered my question with regards to building regs, looking for a bit of general advice here now, I have an existing porch which is timber construction and is in quite a poor state, with the base and roof being sound I would like to replace with a...
  3. P

    Replacement Porch

    Afternoon all, I have an existing porch located on the front elevation of my house, it's approximately 900mm deep and about 2700mm wide, door is located on the right face, window on front elevation approx 1500 wide, smaller window on left elevation approx 850 wide, base is concrete and appears...
  4. P

    New Shower Enclosure Partition Wall

    Afternoon all, this may seem like a silly question so maybe I am over thinking it! I want to put a new enclosure wall in for a shower cubicle, due to the size of the shower the wall will not be supported by the joists (they run parallel to the proposed wall) will noggins install between the...
  5. P

    New Waste Pipe to Sewer

    Afternoon all, looking for a bit of advice here or even if its possible! When the previous owners converted the rear of the garage into a utility room, they ran the waste trap from the sink out to the surface water drainage, obviously I am aware this is not in accordance with building regs so...
  6. P

    Confused yes I am!

    Hi all, currently doing my bathroom, part of which meant ripping out one walls worth of plasterboard due to leaking which had rotted the wall, now after reading many times, seal the plasterboard with PVA I stumbled onto a comment about tanking the walls, So getting to the point, I have new...
  7. P

    6mm or 10mm??

    Following on from a recent posting of mine, electrician is coming out to replace the isolator with a new 45a shower protection unit with RCD, I raised the question over whether the 6mm t&e cable would be sufficient for the new 9.5kw shower to which he said it would be, now he being a expert who...
  8. P

    Possibly replacing electric shower, what other works reqd?

    Hi all, looking at changing my bathroom, currently have an electric shower fitted over the bath but am going to put a replacement electric shower in and a new shower cubicle, looking at my electrics last night I have a seperate unit/switch on the board for the shower rated 30ma with a 30 amp...
Back
Top