Search results

do you have to be gas registered to change a safety valve off the boiler

1 bar on the system... tried bleeding the system... no air in the system... most of my rads are piping hot at the bottom but not at the top... anyone know the problem

as above... i felt the pump and its roasting hot... is the hot water not flowing thru the pump or somethin

Just installed a water tank in attic.. the old tank had its day.. when the tank is just about full it start to make a really loud shaking noise.. probaly the ball valve and the water... how can i correct this problem

have a problem with me car 99 mitsubishi colt... the steering linkage rack and pinion is worn... is this dear to fix

Its a monobloc tap... The hot is grand.. but the cold has being kinda weak pressure and now theres nothing at all.... all upstairs of the tank is grand.. just at the kitchen cold... any ideas

All rads downstairs grand..All grand on 1st floor bar 1... its hot on bottom,tried to vent it but no air or water comes out... and the 1 rad in the attic is stone cold... whats the problem???

Tightened the wing nuts to the max... but my toilet is still leaking... its a close coupeled toilet with a flush button.... it seems to be coming from where the donut is situated.... there is no valve to stop the toilet filling up... whats best way so i can take off the cistern

Going to tile me bathroom... do ya need to put plywood down to tile?? the floor would be to high if i done that and whats a good water sealant for under the tiles

Bath is fairly light... goin to put 2x4 timber on the ground for support.... question is do i have to put battens along the side and front of bath for support aswell

what is the name of the fitting on the 90.... where can i get one? installing a new toilet so want to replace the old gear

Have a sealed system.... with the flow and return at the hwc, the return has a non return and gate valve headin up to the tank.... do i leave this valve open or closed

Upstairs rads were very hot and downstairs not as hot.... so turned off all rad upstairs to see if downstairs get as hot as upstairs but they didnt get hot at all..... whats the problem here...

My rads range from 40-55 degrees in temperature... is that ok or should they be hotter... my boiler is a potterton prima c bout 10 year old

Does anyone have instructions for copper bending with a benders... i had a sheet but lost it....

Have a potterton boiler... gas... 8 rads... the temperature off these rads range from 36degrees - 45 degrees after bleedin them.... is this a low heat output.. have thermostat up full wack.... is there another way to get rads hoter...

For tank in loft... does the ballvalve need to be a part 2??

B&Q toilets.. they all seem to be close coupled but i need a low level one.. can i add a flush pipe to some of them

Got a set of kitchen taps... it says minimum operating pressure 1bar... the mains should be ok... but the hot im not sure.. the hot water cylinder is upstairs

pump on heatin system keeps turning off... i have to knock it off and turn it back on to get it back started... Is it coming to the end?? or just need to be bled