Search results

  1. F

    Miras Realm cartridge

    Hi everyone, My Miras Realm quite suddenly stopped supplying hot water. The problem could either be a blocked inlet filter or it could be a failed cartridge. What do you think is the most likely? Any help would be appreciated. Filmskate
  2. F

    weak flush

    Hi, I have a 6 litre Savoy close coupled toilet -with a Macdee Metro flush syphon in the tank. The flush is weak - have set the volume plug at 9 litres rather than 6 since it works slightly better on that setting - still not good enough though. Is there any way I could improve its performance...
  3. F

    Vaillant ecotec slow start up

    Hi, I've just had a new PCB fitted to my ecotec plus 428. At the start of the day when the room stat called for heat the boiler showed the flame symbol but it just idled for over an hour before firing up for real. Then it worked fine throughout the day. I was advised to adjust the D.0...
  4. F

    1/2" tap connector fibre washer

    I have just replaced a ballcock valve. I reused the fibre washer on the connector and it doesn't seem to be leaking. Is it okay to reuse a fibre washer like this, or might a leak develop in the future. Should one always change them for a new one every time a connector is opened up?
  5. F

    Siting Electric cooker control

    I need to instal a cooker control unit and because of the kitchen decor I can't site it near to the cooker. Does anyone know how far from the cooker is permissable? And can it be installed in the hall outsider the kitchen? - either way it would be sited about a meter from the cooker. Help...
  6. F

    DAMP CHIMNEY BREAST

    Hi there, I have a damp patch on my chimney breast about half way up. The firfeplace was bricked up some time ago - there is an air vent at the base and the chimney pot is capped. There is no rising damp and nothing above. The chimney has recently been swept to clear any debris. The source...
  7. F

    Asbestos garage roof

    Hi, I have an asbestos roof on my garage which needs dealing with. Rather than replacing it I would prefer to coat it with a waterproof coating. Has anyone had experience of a coating product called Kemper 1k PUR which has been suggested? Filmskate
Back
Top