Search results

Hi I have built a small outbuilding and was looking to fit a toilet My main sewer is at the front of the house and i would like to run a 40mm PVC solvent welded pipe from a Macerator,then run a 40mm PVC pipe under ground, the run of pipe would be 6-7 meters meters and then connect into...

Hi Just wondering if you can help I have this type of monobloc tap and the lever handle is lose cold side, how do you take it of to tighten the retaining screw?? Thank you

Hi Fitting a integrated oven, I have solid 40mm wood worktops Do i need any heat shields around or above the cooker, i have a induction hob fitted above the over as well I also have a problem with the oven not fitting, it is too high about 40mm when fitted into the over carcase The...

Hi I am fitting solid wood worktops in my kitchen, Just need a few pointers Do i just use a normal worktop jig to do the joints, And do you lot put oil on the bottom as well as the top to coat both sides I have only one join to do, and i was just going to buy a cheap jig and a good...

Hi all I am fitting out a new kitchen, Just a quick one, i am fitting a integrated oven with grill And a 4 ring fitted hob I have a 30amp supply that goes to a free standing cooker just now, but when i fit the new cooker and hob How does this 2 get wired up Does the integrated over get...

Hi Guys, Need a little help here I have some under 240v cabinet lights and some 12v kickerboard lights to wire up I want to control both lights with a double light switch I am going to take a feed from the lighting circuit down to a double light switch And do a live switch and...

Hi lads Looking at removing the bath and fitting a shower tray Few questions for you Going to remove the bath and do away with it and fit a shower tray Do i just fit a isolation valves and blank hot and cold water supply for old bath under the floor The new show tray waste is...

Hello I had a problem with the hot water tank, funny i had not water So i idid a bit of fault finding today and found no power the the element So i went to the consumer unit and found no power at the MEM AD100 100amp double pole isolater switch so i have swapped it over to a disused...

Hi Need some help and info from you people I have no hot water on my tank but when i put the booster on then i have hot water This make me think that the immersion heater element has gone but the booster part of the element works there is only one heater unit Where can i get a...